Switching The Face Auto Open; Switching The Auxiliary Setting; Switching The Dimmer Setting; Adjusting The Brightness - Pioneer SUPER TUNERIII D DEH-P7950UB Operation Manual

Section
Operating this unit
02

Switching the face auto open

To protect against theft, this unit features de-
tachable front panel. To detach the front panel
easily, the front panel opens automatically.
This function is on as a default.
1 Use MULTI-CONTROL to select
Face auto open.
2 Press MULTI-CONTROL to turn the face
auto open on.
# To turn the face auto open off, press
MULTI-CONTROL again.

Switching the auxiliary setting

Auxiliary equipments connected to this unit
can be activated individually. Set each AUX
source to ON when using. About connecting
or using auxiliary equipments, refer to Using
the AUX source on page 32.
1 Use MULTI-CONTROL to select AUX1/
AUX2.
2 Press MULTI-CONTROL to turn AUX1/
AUX2 on.
# To turn AUX off, press MULTI-CONTROL
again.

Switching the dimmer setting

To prevent the display from being too bright at
night, the display is automatically dimmed
when the car's headlights are turned on. You
can turn the dimmer on or off.
1 Use MULTI-CONTROL to select Dimmer.
2 Press MULTI-CONTROL to turn dimmer
on.
# To turn dimmer off, press MULTI-CONTROL
again.

Adjusting the brightness

You can adjust the display brightness. Initially
this mode is set to 12.
30
En
Black plate (30,1)
1 Use MULTI-CONTROL to select
Brightness.
2 Push MULTI-CONTROL left or right to
adjust the brightness level.
0 to 15 is displayed as the level is increased or
decreased.
# When dimmer is functioning, the brightness
level can be adjusted 0 to 10.
Setting the rear output and
subwoofer controller
This unit's rear output (rear speaker leads out-
put and RCA rear output) can be used for full-
range speaker (Rear SP :F.Range) or subwoo-
fer (Rear SP :S/W) connection. If you switch
the rear output setting to Rear SP :S/W, you
can connect a rear speaker lead directly to a
subwoofer without using an auxiliary amp.
Initially, the unit is set for rear full-range speak-
er connection (Rear SP :F.Range).
1 Use MULTI-CONTROL to select
S/W control.
2 Press MULTI-CONTROL to switch the
rear output setting.
Pressing MULTI-CONTROL will switch be-
tween Rear SP :F.Range (full-range speaker)
and Rear SP :S/W (subwoofer) and that status
will be displayed.
# When no subwoofer is connected to the rear
output, select Rear SP :F.Range.
# When a subwoofer is connected to the rear
output, set for subwoofer Rear SP :S/W.
Notes
! Even if you change this setting, there is no
output unless you turn the subwoofer output
on (refer to Using subwoofer output on page
26).
! If you change this setting, subwoofer output
in the audio menu return to the factory set-
tings.
! Both rear speaker leads outputs and RCA rear
output are switched simultaneously in this
setting.
<CRD4164-A/N>30