Philips FC9722/09 Service Manual page 4

DISASSEMBLY- AND RE-ASSEMBLY ADVISE
• After removing the two buttons remove the 4 screws
at the back and the 5 screws
housing (see pictures).
• Screw D at the front does not need to be removed, this
screw is for ESD and is located in the lower housing.
B
B
C
C
• To replace the potmeter (9) situated at the bottom
of the upper housing, remove knob (7) on top of the
upperhousing and remove the 2 scews
of the upper housing (see picture).
C at the front of the upper
B
C
C
D
C
E at the bottom
E
E
FC9722/09 / FC9722/19
• After removing the upperhousing, Hose connection (10)
B
and Bucket inlet sealing (13) are accessible. To replace
the hose connection screw
B
• To replace Cordwinder (24) or Motor (31) Motor housing
(28) has to be removed, this can be done by removing
the 4 screws
Remark:
A special long screw driver is needed!
• To replace the PCB (9) remove the 2 short screws H.
F has to be removed.
F
G (see picture).
G
H
G
G
H
G
4-11