Taking Photos; Mounting Your Camera - ION Camocam Wi-Fi Quick Start Manual

Notes:
1. An additional 432x240 (w/ 1080p/720p) or 320x240 (w/ 960p) video file will be created
simultaneously with the recording of an HD/FHD video file. The smaller video file size
allows for more efficient uploading of content to social media platforms and email.
2. Changing video resolution is disabled during video recording.
3. There will be around 1-2 seconds delay before the camera starts recording.
4. The various video resolution options for HD and FHD can be changed under the
"Settings" section in the iON software. (see section 5)

3.6 Taking Photos

1. Turn on the camera by pressing the Power
2. After the camera power has been turned on, press the Power
take a photo. A short vibration and a flash of the green LED indicates that the action
was successful.
Notes:
1. The Still Photo function is disabled during video recording.
2. Change photo resolutions and shooting mode (Single Shot, Burst Mode and Time
Lapse) through the "Settings" section on the iON software.

4. Mounting Your Camera

4.1 Secure Strap
1. Loop one end of the secure strap through
the strap hole of the camera. You may use a
pin to help thread it through the hole.
2. Attach the other half to the mount.
3. Clip both ends together when camera is mounted.
4.2 CamLOCK
iON's versatile CamLOCK Mount System allows you to
attach the camera to any type of helmet (bike, motorcycle,
ski, skydive etc.), pole, board (surf, skate, ski etc) and
button.
EN-6
button very briefly to