Safety Precautions
This installation manual explains how to install the power distribution unit.
See the appropriate installation manual for other optional accessories.
WARNING
CAUTION
2
E-
N Read this installation manual carefully before
installation and check whether the power distribution
unit is installed properly.
N Do not attempt to install or repair the power
distribution unit by yourself.
N Always consult an authorized service personnel for
repair.
N When moving, consult an authorized service
personnel for disconnection and reinstallation of the
power distribution unit.
N Ensure that the wall is strong enough to support the
weight of the power distribution unit.
N The power distribution unit must be installed with the
rated power supply.
N The power distribution unit must be installed
according to the national electrical rules by an
installation specialist.
N Consult an authorized installation center on how to
dispose the power distribution unit.
N Do not use inflammable gases near the power
distribution unit.
N Do not install the power distribution unit in a location
where it will come into contact with combustible
gases, machine oil, sulphide gas, etc.
N Avoid a location where acid/alkali solution or special
spray is used.
N Install the power distribution unit in a location that is
not exposed to direct sunlight and where the
temperature range is between 0°C and 39°C.
N Do not let water into the power distribution unit.
N Do not apply pressure to the cable.
The cable may break and cause fire.
N Do not press the buttons with a sharp object.
N Do not connect the power cable to the control terminal.
N Ensure that the power distribution unit does not affect
other electronic devices when installed in a hospital
or other particular places.