Page 1
This will allow the recycling of raw materials and help protect the environment. FOR HELP OR ADVISE ON THIS PRODUCT PLEASE CONTACT YOUR DISTRIBUTOR, OR SIP DIRECTLY ON: 01977 TEL: 01509500400 EMAIL: sales@sip-group.com or technical@sip-group.com Please read and fully understand the instructions in www.sip-group.com...
LE12 9NH England As the manufacturer's authorised representative within the EC declare that the 7 Ton log splitter - SIP Pt. No. 01977 Suppliers Part No. LS7S Conforms to the requirements of the following directive(s), as indicated. 2006/95/EC Low Voltage Directive...
Page 4
Lever Handle WD03-00094 SIP recommends that this log splitter should not be modified or used for any applica- Right Guard Assy WD03-00095 tion other than that for which it was designed. If you are unsure of its relative applica-...
Page 5
SAFETY INSTRUCTIONS….cont EXPLODED DIAGRAM dry area, out of reach of children. Do not unplug the log splitter to switch it off - always use the on/off switch. Never stand on the log splitter. DO NOT dismantle or tamper with the log splitter, as this may be dangerous and will invalidate the warranty.
Page 6
Connecting to the power supply: This SIP log splitter is fitted with a standard 230v ~ 13 amp type plug. Before using the log splitter, inspect the mains lead and plug to ensure that neither are damaged. If any damage is visible have the log splitter inspected / repaired by a suitably quali- fied person.
Page 7
Reverse polarity by electri- This SIP log splitter is covered by a 12 month parts and labour warranty covering failure cian. due to manufacturers defects. This does not cover failure due to misuse or operating Valve is not opened owing to Check and tighten the parts.
Page 8
UNPACKING YOUR LOG SPLITTER MAINTENANCE INSTRUCTIONS IMPORTANT: At least 2 people are required to unpack the log splitter package. Replacing The Hydraulic Oil: Take the following steps to put the log splitter onto the ground and remove the pack- The hydraulic system is a closed system with an oil tank, oil pump and control valve, aging by tipping every side of the carton by 45 degrees and opening the correspond- check the oil level regularly with the dipstick, low oil levels can damage the oil pump, ing flap.
Page 9
OPERATING INSTRUCTIONS….cont GETTING TO KNOW YOUR LOG SPLITTER CAUTION: Break the log in the direction of its growing grain, do not place log across the log splitter for splitting, it may be dangerous and may seri- ously damage the machine. 9.
Page 10
GETTING TO KNOW YOUR LOG SPLITTER….cont OPERATING INSTRUCTIONS….cont Warning Labels Attached To The Log Splitter: CAUTION: Do not attempt to split logs that are too “green.” Dry, seasoned logs split much more easily, and will not jam as frequently as green wood. Read and understand the owner’s manual and labels affixed to the log splitter.
Page 11
OPERATING INSTRUCTIONS….cont GETTING TO KNOW YOUR LOG SPLITTER….cont IMPORTANT: Always open the hydraulic oil filler cap before using the log splitter and keep it open during operation. When not in operation ensure the hydraulic oil filler cap is fully closed. Do not wear loose clothing, gloves, neckties or jewellery (rings, wrist watch- es).
Page 12
TECHNICAL SPECIFICATIONS ASSEMBLY INSTRUCTIONS ….cont Part No. 01977 Input 230v ~ 50Hz, 3000w There are 3 positions available for the Log Capacity - Ø 120 mm - 320 mm support table for different splitting lengths 104cm / 78cm / 52cm.
Need help?
Do you have a question about the 01977 and is the answer not in the manual?
Questions and answers