Setting The Automatic Connection; Setting Automatic Answering; Echo Canceling And Noise Reduction; Switching The Ring Tone - Pioneer SUPER TUNER III D FH-P8000BT Operation Manual

Operating this unit
4 Use the cellular phone to perform
phone book transfer.
Perform phone book transfer using the cellu-
lar phone. For detailed instructions, refer to
the instruction manual that came with your
cellular phone.
# Depending on the cellular phone, phone book
can only be transferred one by one.
# The display indicates how many entries have
been transferred and the total number to be
transferred.
5 DATA TRANSFERRED is displayed and
phone book transfer is completed.

Setting the automatic connection

It is possible to set the automatic connection
between your cellular phone and this unit. If
this function is set to on, connection between
your cellular phone and this unit will take
place automatically as soon as the two devices
are less than a few meters apart.
! With some cellular phones, it may not be
possible to perform the automatic connec-
tion.
1 Display the function menu.
Refer to Introduction to advanced operations
on page 39.
2 Use MULTI-CONTROL to select
AUTO CONNECT.
3 Press MULTI-CONTROL to turn auto-
matic connection on.
# To turn automatic connection off, press
MULTI-CONTROL again.
Note
Automatic connection is performed in the regis-
tration number order.

Setting automatic answering

1 Display the function menu.
Refer to Introduction to advanced operations
on page 39.
2 Use MULTI-CONTROL to select
AUTO ANSWER.
3 Press MULTI-CONTROL to turn auto-
matic answering on.
# To turn automatic answering function off,
press MULTI-CONTROL again.

Echo canceling and noise reduction

1 Display the function menu.
Refer to Introduction to advanced operations
on page 39.
2 Use MULTI-CONTROL to select
ECHO CANCEL.
3 Push MULTI-CONTROL left or right to
select the desired setting.
OFF (off)—LOW—MID—HIGH
# This function can be performed even while
talking on the phone. In this case, press
MULTI-CONTROL to switch to ECHO CANCEL.

Switching the ring tone

1 Display the function menu.
Refer to Introduction to advanced operations
on page 39.
2 Use MULTI-CONTROL to select
RING TONE in the function menu.
3 Push MULTI-CONTROL left or right to
select the desired setting.
OFF (off)—BEEP1—BEEP2—BEEP3
Section
02
41
En