Operating The Appliance; Grilling With Water And Lava Stones; Switching On Or Off; Setting The Grill - Siemens ET375FUB1E Instruction Manual

Operating the appliance

en
1Operating the appliance
In this section, you can find out how to set your
p l i a n c e O p e r a t i n g t h e a p
appliance. In the table, you can find the settings for
various dishes.

Grilling with water and lava stones

Fill the grill container with water before each use.
Note:
Otherwise the appliance will overheat.
The amount of water depends on whether you want to
use lava stones. The lava stones store the heat from the
grill element, leading to intense radiation of heat and
even heat distribution.
Filling with water and lava stones
Remove the wire rack and fold up the grill elements.
1.
Remove the lava stone container from the appliance.
Ensure the drain valve is closed.
2.
Pour water into the grill container.
3.
Grilling with lava stones: 0.7 litre (bottom mark)
Grilling without lava stones: 2.5 litres (top mark)
To grill with lava stones: Remove the lava stones
4.
from the packaging and place them in the lava stone
container. Insert the lava stone container in the
appliance.
Fold down the grill heating element and replace the
5.
wire rack.
The grill is ready to use.

Switching on or off

The appliance switches off automatically when
Note:
the grill setting remains at 0 for more than 20 seconds.
Switching on
Touch the symbol.
#
An audible signal sounds. The indicator above the main
switch lights up. The appliance is ready to use.
22
Switching off
Touch the symbol until the indicator above the main
#
switch goes out.
The appliance is switched off. The residual heat
indicator remains lit until the appliance has cooled
down sufficiently.

Setting the grill

Set the desired grill setting on the control panel.
Grill setting 1 = lowest output
Grill setting 9 = highest output
Setting the grill setting
Switch on the grill using the main switch
1.
Slide your finger across the control panel until the
2.
desired grill setting appears in the display.
The heating indicator flashes.
The grill regulates the temperature by switching
Note:
the grill element on and off. The grill element may also
switch on and off at the highest setting.

Preheating the grill

Only place food on the grill when the preheating time
has elapsed. The preheating symbol goes out. During
the preheating time, the grill heats up at full power.
Thereafter, the temperature is reduced by the heating
elements being switched on and off in order to maintain
a constant temperature for the respective setting.
The preheating time can be between 8 and 10 minutes,
depending on the grill setting.
Preheat the empty grill for a maximum of
Note:
8-12 minutes. A longer preheating time could result in
the appliance switching off (overheating protection).
Switch the appliance off and leave it to cool down
before switching it on again.
# .