Related Manuals for Parmco HX-1-6S-4E
Summary of Contents for Parmco HX-1-6S-4E
- Page 1 Installation and Operating Instructions Model: HX-1-6S-4E HX-1-6W-4E For your convenience, we recommend to attach the serial number label HERE. 727626032017...
- Page 2 Dear Valued Customer, Thank you and congratulations on purchasing your new Parmco appliance. All Parmco products are made to the highest quality and design standards. We are sure you will enjoy your new appliance. As a note, please read through these instructions carefully. These will assist you appliance.
- Page 4 INDEX Important Safety Warnings Product overview Top view Before using your Electric Hob Using your Electric Hob To start cooking Advice on the use of cooking tops Cleaning and Maintenance Troubleshooting Technical Specifications Installation...
-
Page 5: Important Safety Warnings
If malfunctions occur do not attempt to repair the appliance yourself. First refer to the troubleshooting section of this manual. If you do not find the necessary information, contact a service agent or the Parmco's Service Department. Servicing work on this appliance must be carried out by a qualified technician only. Always request the use of original spare parts. -
Page 6: Indicator Light
Large Plate Small Plate Knob Red Spot Indicator Light Large Plate Small Plate Before using your Hob Use pans with flat bottoms. Uneven or thin bottoms will waste energy and are slow to cook. Use pans slightly larger than the hotplates. Smaller pans will waste energy. Do not use oversized pans. -
Page 7: Using Your Hob
Using your Hob Operation of the electric plates The electric plates can be standard or rapid type. The rapid type plates are distinguished by a red mark at the centre. According to your needs, the heat of the plates can be adjusted by turning the knobs either clockwise or anti-clockwise, to any of the 6 positons besides “0”... -
Page 8: Important Notice
2. Check if there is a power outage. 3. Call a qualified electrician or Parmco. The surface is scratched. Use of improper cookware. 1. Use cookware the flat smooth bases. Refer to “Choosing the Unsuitable, abrasive cleaning products correct cookware”... - Page 9 Model HX-1-6S-4E & HX-1-6W-4E Cooking Zones Supply Voltage 220-240V~ 50Hz Power 1000W(145mm) 1500W (185mm) 2000W (185mm- Red Centre) Product Size LxWxH(mm) 580x500x76 Cut-out Dimensions 557(L)x477(W)
-
Page 10: Dear Installer
Installation Dear Installer: Please affix data label provided on the adjacent cupboard near the appliance for future reference. Thank you. This appliance must only be installed only an authorised personnel and in accordance with the current New Zealand building and installation standards. All laminates, fixing adhesive and surfacing materials should be certified suitable for installation of this appliance. -
Page 11: Electrical Connection
Electrical connection The connection cable must be secured in a strain-relief clamp. The electric supply of the hob must have an isolation switch which enables you to disconnect it in case of an emergency or maintenance. When the appliance is to be installed above a built-in oven, the two appliances must be connected separately, to make it easier to take the appliances out and for electrical safety. - Page 12 Before inserting the hob into the work surface, place the adhesive seal around the underside edge of the hob. It is important to fix the seal evenly without gaps, to prevent liquids from seeping underneath the hob. Turn the hob upside down (ensure the surface will not damage the hob). Place the gasket around the bottom edge of the hob.