General Connections - Lec 444443640 User Manual

1. SAFETY AND INSPECTION
In order to inspect the unit before starting it up, the following checks should be taken into account:
• Do not modify the specifications plate or instructions issued by the manufacturer.
• Do not remove or modify the safety elements.
• Do not touch the unit with wet or damp hands and feet.
• Do not touch the unit when barefoot.
• Do not pull the cable to unplug the unit.
• Before carrying out any cleaning or maintenance operation, unplug the unit from the electricity
supply, first turning off the main switch and then unplugging the unit.
• The unit should not be used in threatening atmospheric or fire risk conditions.
• Avoid the use of adapters, extension leads or multiple plugs.
• The unit must not be used by children, persons whose mental, sensory or physical capacities
are impaired. Persons who lack experience or knowledge must be supervised or given instruc-
tions for use.
• Check that the voltage and power line frequency coincide with those indicated on the specifica-
tion plate of the appliance.
• Check that there are not defects on the unit resulting from its transportation. The manufacturer
will not be liable for damage suffered during transportation or arising from incorrect storage.
• Check the operation of the moving components of the unit.
• Check the safety of the control board, electrical cables and connections.
• Check that all the interior and additional accessories are present.

2. GENERAL CONNECTIONS

Before connecting the unit to the power supply, check that the voltage and the power line frequency
coincide with those indicated on the specification plate of the appliance.
It is essential that the electrical installation to which the unit is going to be connected has an
EARTH LEAD, as well as the necessary thermal and differential magnetic protection.
The power supply must have the suitable section for the consumption of the appliance.
When the unit is connected and started-up, depending on the model, a control light is displayed on
the switchboard.
If various units are installed in a row, each one must be connected independently to the power supply,
avoiding the use of extension leads or multiple plugs.
The manufacturer disclaims all liability in the event that any of the above points are not followed.
www.lec-commercial.co.uk
6