Access Web Management Interface - Nexcom IWF2220 User Manual

2.4 Access Web Management Interface

NEXCOM Access Points support web-based configuration. When hardware installation is complete, the AP
can be configured through a PC by using a web browser.
The default values of the AP's LAN IP Address and Subnet Mask are:
IP Address: 192.168.1.1
Subnet Mask: 255.255.255.0
Example of entering the AP's default IP Address into a web browser

To access the web management interface (WMI), connect the administrator PC to the LAN port of the
AP via an Ethernet cable. Then, set a static IP Address on the same subnet mask as the AP in
TCP/IP settings of your PC, such as the following example:
IP Address: 192.168.1.100
Subnet Mask: 255.255.255.0
Please note that the IP Address used should not overlap with the IP Addresses of

Note:
any other device within the same network to avoid IP conflict.

Launch the web browser on your PC and enter the IP Address of the AP (192.168.1.1) at the address
field, and then press Enter. The following Administrator Login Page will appear. Enter "admin" for
both the Username and Password fields, and then click Login.
12
User's Manual
Light Industrial AP ENGLISH
Copyright © NEXCOM, INC.