Related Manuals for Eskimo ES 2060 W
Summary of Contents for Eskimo ES 2060 W
- Page 1 COOKER HOOD INSTRUCTON MANUAL Read this manual carefully before operation Pictures in this manual are for reference only, the product in kind prevail. ES 2060 W ES 2060 BL ES 2060 INOX...
-
Page 2: Table Of Contents
CONTENTS WARNING ……………………….……………………………. MAIN PARAMETERS ……………………………………….. DESCRIPTION OF THE DEVICE ………………………….. INSTALLATION ………………………….…………………… OPERATION ……………………….…………………………. REPLACING BULB ………………………………………….. CLEANING AND MAINTENANCE …………………………. DISPOSAL ……………………………………………………. EN-2... -
Page 3: Warning
WARNING 1. There shall be adequate ventilation of the room when the range hood is used at the same time as appliances burning gas or other fuels. 2. Do not check the status of the filters while the cooker hood is operating. - Page 4 14. To protect the main body from corrosive of the long time accumulation of dirt, the cooker hood should be cleaned with hot water with non-corrosive detergent every two months. 15. The air must not be discharged into a flue that is used for exhausting fumes from appliances burning gas or other fuels.
-
Page 5: Main Parameters
MAIN PARAMETERS Rated Voltage and Frequency: 220-240V~ 50/60Hz (For Some Models) 110-127V~ 60Hz (For Some Models) Motor Input Power: 200W In certain circumstances electrical appliance may be a danger hazard. DESCRIPTION OF THE DEVICE The cooker hood Other accessories: 1. Air Duct Assembly 5. -
Page 6: Installation
INSTALLATION Before installing your wall canopy: Please read the instructions carefully. Unpack the canopy and check that all functions are working. Ensure that the voltage (V) and the frequency (Hz) indicated on the serial plate match the voltage and frequency at the installation site. ... -
Page 7: Prepare The Installation
Information Sufficient air is needed for proper combustion and exhaustion of gases through the flue (chimney) of fuel burning equipment to prevent back drafting. Ductless fans must always be vented to the outdoors. When assessing the air pressure, the entire ventilation system in the house/apartment must be taken into account, e.g. - Page 8 to be fulfilled. The cooker hood must be placed at a minimum distance of 65cm above the cooking surface of a hob. Cupboard mounting installation: 1. Drill a 130mm diameter and four 3.5mm diameter hole as below picture. ATTENTION: If your cooker hood works at circulating-air mode, it is not necessary to drill 130mm 480/675/696...
-
Page 9: Operation
Information The air must not be discharged into a flue that is used for exhausting fumes from appliances burning gas or other fuels. OPERATION Switch A: OFF MOTOR SWITCH: Press on this switch to stop the motor operation. SPEED SWITCH: Press on this switch, the motor runs at LOW speed. -
Page 10: Replacing Bulb
REPLACING BULB 1. Switch off the extractor hood and isolate the extractor hood by pulling out the mains plug or switching off the fuse. 2. Remove the grease filter. 3. Replace the lamp (commercially available filament lamps (max.40W) or halogen lamp (max. 28W) E14 type). -
Page 11: Disposal
2. Rinse thoroughly with warm water and leave to dry. 3. The metallic filter may alter in color after several washes. This is not cause for customer complaint or replacement of metallic filter. Information There is a fire risk if cleaning is not carried out in accordance with the instructions. - Page 12 The manufacturer shall decline all responsibility if the foregoing recommendations and instruction regarding installation, maintenance and use are not observed and respected when using the cooker hood. Guangdong Midea Kitchen Appliances Manufacturing Co.,Ltd No.6 YongAn Road, Beijiao, Shunde, Foshan, Guangdong, China...
Need help?
Do you have a question about the ES 2060 W and is the answer not in the manual?
Questions and answers