Get Started; What's In The Box (Fig. A); Product Version Table - Philips SHC5100 User Manual

E n g l is h

1 What's in the box (Fig. A)

1) Headphones
3) AC/DC adaptor
5) 2 x AAA rechargeable shortened sleeve NiMH
batteries (SBC HB550L)

2 Get started

Note
•
Before using the headphones for the first time, charge the
supplied batteries for at least 10 hours.
•
Only use Philips rechargeable shortened sleeve NiMH
batteries with your headphones. Other types of
rechargeable batteries cannot be charged with this system.
•
AAA alkaline batteries can be used to operate the
headphones, but cannot be charged with this system.
•
If the volume of the audio source is insufficient, the
transmitter automatically turns off.
1
Install/Replace supplied batteries (Fig. B).
2
Install the antenna tube into the transmitter (Fig. C).
3
Power on the transmitter (Fig. D).
» Red LED is on when audio source is connected.
» Red LED blinks if no audio source is connected for
two minutes.
» Red LED is off if no audio source is connected for four
minutes.
4
To charge the headphones, connect the charging cable
with the headphones (Fig. E).
» Headphones: red LED is off during charge.
» Transmitter: green LED is on during charge and is off
when headphones are fully charged.
5
Power on the headphones and red LED is on (Fig. F).
6
Connect the audio device with the transmitter (Fig. G).
» Red LED is on when audio source is connected.
Tip
If there is interference, tune the transmitter and the headphones
to the same channel (Fig. H).

3 Product version table

Version / Region
Input voltage / frequency
Output voltage
Carrier / Reception
frequency
Transmission power
For further product support, please visit
www.philips.com/support
2) Transmitter
4) Antenna tube
Channel 1
Channel 2
/10 Europe
100-240V / 50/60Hz
8V 200mA
863.5MHz
864.5MHz
<8 dBm
/05 UK