Samsung NA30K6550T SERIES Installation Manual page 15

Correct installation
Front of unit
Hold down
bracket holes
Gas inlet
Power cord
Hold Down Bracket Installation
Install_NA9300K_DG68-00841A-01_EN+MES+CFR.indb 15
1. Locate electrical outlet and gas shut-off
valve beneath cabinet.
2. Apply the foam tape around the edge of
the cutout opening. Do not overlap the
foam strips.
• The foam strip helps avoid damage
to the underside of the cooktop from
debris and helps the cooktop sit flat on
uneven counters.
3. Protect surface of cooktop
• Place a towel or tablecloth onto the
countertop.
4. With bottom side first, gently put the
cooktop down. Then, slightly lift up the
rear to remove the protective rubber for
the Wi-Fi module.
• Make sure the front of the countertop is
parallel to the cooktop
• Make final check that all required
clearances are met.
5. Secure the cooktop to the countertop
using the two provided hold-down
brackets as shown.
Hold down bracket install guide
Case 1.
Countertop
Side wall of
undercounter
Chassis
cabinet
Hold down
M4 L10 screw
bracket
M4 L16 screw
NOTE
Smart Connect module can/must be detached before installation of the cooktop in
folowing cases:
• The consumer doesn't need to Smart connect function.
• Installation is not possible because the Smart Connect module protrudes against
the rear wall of the countertop.
• The downdraft hood is installed and protrudes against the Smart Connect
module.
The Cover must be installed in place of Smart connect module if Smart connect
module has been removed. Please read following instructions on how to detach
Smart connect module.
Case 2.
Countertop
Chassis
Hold down
bracket
M4 L10 screw
W / L75 screw
3
16
English 15
12/12/2016 9:31:35 PM