Table of Contents
Advertisement
Install the AutoCube Camera
Caution: DO NOT remove the protective foam during
1.
Angle the clamp on the top of the pole perpendicular to the
pole. Turn the knob to loosen the clamp.
2.
Insert the ball of the camera into the clamp. Make sure the
camera is right side up (Honeywell logo on front right side
up). Adjust the camera to the correct angle (A) from the pole
(see Dimensions at the beginning of this document).
3.
Turn the knob to tighten the clamp. Be sure it is tight
enough so that the camera will not move.
4.
Attach the USB cable at the top of the pole to the camera.
Secure the cable to the camera by tightening the screws by
hand.
Knob to tighten or
loosen clamp
Note: Be sure the camera is horizontal to the measurement area
and aimed directly at the area.
installation.
8
Advertisement
Table of Contents
