Quick Coding - Leica Geosystems CS15 Technical Reference Manual

25.4
Requirements
Activate quick coding
Performing Quick
coding
Viva Series, Coding

Quick Coding

• The job codelist contains quick codes for points, lines and/or areas.
• According to the user requirements, set Store free code: Before pt is stored or Store free
code: After pt is stored in Coding & Linework Settings, Quickcoding.
The current setting for Quickcoding in the Quickcoding page determines how quick coding
is activated. Quick coding can be activated at any time.
• For Quickcoding: On, Quick coding is active and can be used.
• For Quickcoding: Off, use a hot key, the
icon.
• For Quickcoding: Never, change the setting manually.
A screen must be active where points can be measured.
Type in the one, two or three digits of the quick code. The current setting for Digits to use
in Coding & Linework Settings, Quickcoding page determines by how many keystrokes
quick coding is executed.
Press ENTER to execute quick coding after less than the configured keystrokes. This action
is possible after one keystroke for Digits to use: 2 and one or two keystrokes for Digits to
use: 3.
Press ESC to clear digits from the entry.
Only mandatory attribute values can be entered. For non-mandatory attributes, either the
default or the last used attribute values are stored, depending on the setting for Suggested
attributes in Coding & Linework Settings, Code & attributes page.
favourites menu or tap the quick coding
550