Installing Your New Appliance - Hisense RB468N4BC2 User's Operation Manual

7

Installing your new appliance

Before using the appliance for the first
time, please consider
tips.
Ventilation of appliance
In order to improve efficiency
of the cooling system and save
energy, it is necessary to maintain
good ventilation around the appliance
to allow dissipation of heat. For this
reason, sufficient clear space should
be available around the refrigerator.
It is advisable for there to be at least
75mm of space from the back to the
wall, at least 100mm from its top,at
last 100mm from its side to the wall
and a clear space in front to allow the
doors to open 135°
following diagrams.
Note:
This appliance performs well within
●
the climate class showed in the table
below.
It may not work properly if being left at
a temperature above or below the
indicated range for a long period.
Ambient temperature
Climate class
SN
N
ST
T
Stand your appliance in a dry place
● ● ● ●
to avoid high moisture.
Keep the appliance out of direct
●
sunlight rain or frost. Stand the
，
appliance away from heat sources
such as stoves, fires or heaters.
the following
as shown in
100
100
+10C to +32C
+16C to +32C
+16C to +38C
+16C to +43C
Hisense Refrigerator
Leveling of appliance
For sufficient leveling and air
●
circulating in the lower rear section of
the appliance, the bottom feet may
need to be adjusted. You can adjust
them manually by hand or by using a
suitable spanner.
To allow the doors to self-close, tilt
●
the top backwards by about 10mm.
Installing the door handles
For the convenience of transportation,
the door handles are separately
provided in a plastic bag, you can
install the door handles as follows.
1. Lever out screw covers on the left
side of the door, and then put them
back in to the plastic bag.
2. Match the handle on the left side of
the door, keeping the center of the
screw holes in the handle and the
door in a line, as the picture shows.
3. Fix the handle with the special
screws provided in the plastic
bag. Then install the handle covers.
≤10mm