Table of Contents
Advertisement
Available languages
Available languages
Therefore, please remove the battery if the camera will
not be used for a long time.
4..Advanced.operations
From the basic operations of the camera in the previous
chapter, we know that the camera has three basic
operation modes:
1..OFF.mode: Power switch is in OFF position.
2..ON.mode:
Power switch is in ON position.
3... T EST.mode: Power switch is in ON position and the
control is connected to the camera.
The OFF mode is the specified safe mode for replacing
the SD-card or batteries and transporting the camera.
ATTENTION!
Replace SD-card only in OFF mode!
4.1.Settings
To make any specific settings the wired control must be
connected with the camera and an SD-card must be installed.
Then, change into the TEST mode explained before.
To open the settings menu, press MENU on the wired control.
The settings menu will be shown on the control's LCD.
28
Setting.items
Description
Camera Mode
Choose capturing images or recording
videos.
Format
Format the SD-card. All images and
videos on the SD-card will be deleted.
Video Size
Choose the video size, e.g. 640×480
(VGA) or 1280x720.
Set Clock
Set camera date and time.
Capture Number
Choose the continuous shooting
numbers after each triggering.
Video Length
Choose duration of recording videos.
Interval
Choose how long the camera will stop
functioning after each triggering. The
camera's PIR will be disabled during this
interval.
Sense Level
Choose sensitivity of PIR. The higher,
the easier the motion sensor would be
triggered. It is recommended to use
Normal mode. The sensitivity of PIR
is strongly related to the temperature.
Higher temperature leads to lower
sensitivity. Therefore, you may need to
adjust sense level to an appropriate value.
Advertisement
Table of Contents
