Advertisement
Recording with Physilog
Start
• Put all of your sensors on a
table
• Press on the ON/OFF button for
1-2 seconds (green LED on and
off again)
• The LED is blinking
green
every
second - For synchronous
measurement, refer to the
"Practical considerations" page.
• > Physilog® is recording
Charging and Data Transfer
Plug
•Plug the micro USB to the
Physilog®
•Plug the USB to the
Computer or Charger
*
Attach
• Fix the Physilog® on the subject
www.gaitup.com © 2015
Charging
•When connected to the
computer via USB port or
*
a charger
, the LED blinks
orange
•> Physilog is charging
•When it is fully charged,
it shines
green
*Charger is not provided by Gait Up. Gait Up
declines any responsibility due to charger
usage. Please refer to supply voltage in the
product specification section.
www.gaitup.com © 2015
Sense
• Ask the subject to perform a
movement according to your
protocol
Connect
•When connected to a
computer, the LED is
blinking
multicolor
•Wait for few seconds
•>Physilog® is connected
to your computer
Stop
• Once the subject has finished,
press again on the button for a
few seconds
• The LED shines orange, then
blinks 3 times
green
and then
turns off
• > Physilog® has created one file
and stopped recording
Transfer
•Copy and paste Physilog®
files (*.bin) to your
preferred destination
Advertisement
