Frequent Questions And Answers - UK Segboards smart segboard User Manual

10) Frequent Questions and Answers

1) If it doesn't feel balanced under your feet?
Each wheel is connected to a separate motor. It is therefore important that
both motors must be synchronised with each other for a smooth ride. In
order to do that please follow the below instructions;
- Switch off the board
- Level both the pedals/sides so that they exactly aligned with each other
- Press the power button and keep it in pressing position. After a few
seconds, the lights will both start blinking
- Once the blinking stops, after one or two seconds they will be turned
on for a few seconds however they will be in steady state at this time.
They sync process is complete
- Switch off the device and turn it back on again. It is now ready to ride
- Please note: During the sync process keep the Segboard steady
as sliding/movement will affect the sync process.
2) How to use the Bluetooth for the Bluetooth Segboard?
Pair your phone with the board Bluetooth and play the music on your
phone.
3) How to charge?
Connect the charger socket to the port and switch on device. You will
see battery mode light starts blinking, when fully charged the light will
change colour to green. For first time use, please charge it for around
2/3 hours.
4) If the board doesn't start for the first time?
Please fully charge the board, if it still doesn't work please speak to us
for technical help and advice.
5) Precautions;
Please keep it away from moisture and water. Please DO NOT use it in
rainy or wet conditions.