Table of Contents
Advertisement
Visual indication of how a channel is panned is
provided on the display by way of speaker icons
located above the left and right bargraphs.
+Vol 12
1
Preset 1
Preset 2
PSU 1
PSU 2
L
R
Ch 1 routed Left
+Vol 12
1
Preset 1
Preset 2
PSU 1
PSU 2
L
R
Ch 1 routed L & R
Note: routing a channel to the mix can only happen
in audition mode, i.e., only when the blue Channel
Select LED is flashing. If the LED is not flashing then
it is not possible to route the channel to the current
mix.
Following the above procedure it is possible to add
additional channels to the monitor mix. Each channel
in the mix will be identified on the front panel by its
associated blue Channel Select LED being illuminated.
Note: as additional channels are added the overall
mix is compensated to accomodate them. Therefore
quiet or silent channels will result in the overal
volume being attenuated. It is recommended that
the channels chosen be limited to those that actually
have audio on them.
Hint: To clear the slection of multiple channels to the
monitor mix, press and hold the CLR button.
Presets
Two presets are available to store and easily recall
monitor mixes.
Storing a Preset
•
With the desired channels selected (indicated by
their blue Channel Select LEDs being illuminated)
choose which Preset location to use.
•
Press and hold the chosen Preset button (either
Preset 1 or Preset 2: see item
Panel Description" on page 7).
12
BM-A1-64DANTE User Manual v1.1
+Vol 12
1
Preset 1
Preset 2
PSU 1
PSU 2
L
R
Ch 1 routed Right
+Vol 12
1
Preset 1
Preset 2
PSU 1
PSU 2
L
R
Ch 1 not routed
on "Front
•
The Preset button will flash. Continue to press
the button until the button stops flashing.
•
The Preset has now been stored with the current
monitor mix.
Recalling a Preset
•
Press the desired Preset button on the front
panel. The preset will load and will be confirmed
on both the front panel display and also by the
appropriate blue Channel Select LEDs illuminating.
+Vol 0
Preset 1
Preset 2
PSU 1
PSU 2
Preset 1 loaded
Clearing a channel from the
monitor mix
It is possible to clear a channel from the current
monitor mix by reselecting it using the SEL encoder
and while the blue Channel Select LED is flashing,
push the encoder enough times so that the channel
is neither routed to the left or right speakers. This is
indicated by the speaker icons not being visible above
the bargraph meters. With no speaker icons visible,
the channel is no longer routed to the monitor mix.
+Vol 12
Preset 1
Preset 2
PSU 1
PSU 2
Channel 1 not routed.
Clearing an entire monitor mix
To clear an entire monitor mix use the CLR button
on the front panel. As a safety precaution against
accidentally clearing a monitor mix it is necessary
to push and hold the button for approximately two
seconds in order to clear the monitor mix. When
pressing the CLR button it will flash. Once the CLR
button stops flashing the monitor mix is cleared.
1
L
R
1
L
R
Bel Digital Audio Ltd
Advertisement
Table of Contents
