The information contained in this manual has been carefully checked for accuracy; however no guarantee is given with respect to its correctness. Bel Digital Audio Ltd. accepts no responsibility or liability for any errors or inaccuracies that may appear in this manual or the products and software described in it.
Important Safety Instructions ......4 Important Safety Precautions ......5 Important Safety Information ......5 Introduction ...........6 What’s In The Box ......... 6 BM-A1-64DANTE Main Features ..... 6 Front Panel Description ........7 Rear Panel Description ........8 Installation ............9 Hardware Considerations ....... 9 Power Supply Considerations ......
125% of current rating is suitable. The minimum rating for the power supply cord at 110 / 230V ac to be 1A. BM-A1-64DANTE User Manual v1.1 Bel Digital Audio Ltd...
HRC type (High In-Rush Current) fuse with a rating of 1 A. Warning: Excessive sound pressure levels from headphones can cause hearing loss. Bel Digital Audio Ltd BM-A1-64DANTE User Manual v1.1...
Unpacking Unpack the BM-A1-64DANTE with care. It is always a good idea to store all packaging (if practical), in case you ever need to return the unit to Bel for any reason. The shipping carton should contain the items listed below.
MUTE – Pressing this switch mutes the front speakers and the headphone output Preset 1 and 2 – Two preset memory locations are available to enable instant recall of user channel monitor combinations. Bel Digital Audio Ltd BM-A1-64DANTE User Manual v1.1...
– RJ45 Dante port for the secondary (redundant) network. USB – Type B USB socket providing access for firmware updates. PSU1, PSU2 – AC inputs, 2 x IEC sockets. Autoranging from 100 to 240 V AC 50/60 Hz. BM-A1-64DANTE User Manual v1.1 Bel Digital Audio Ltd...
Installation Hardware Considerations Unit Connections The BM-A1-64DANTE is built in a 1U 19” enclosure. DANTE Inputs It is intended to be permanently installed in a BM-A1-64DANTE provides DANTE standard 19” equipment rack. There are ventilation RJ45 Ethernet connections (PRIMARY grilles in the top, bottom and both sides of the SECONDARY).
Dante monitor does not change then there is no requirement to run As the BM-A1-64DANTE is a monitoring device, it the Dante Controller application again. is highly likely that the Dante Controller is already installed and operating on the existing Dante network.
Single channel monitor mode is the default mode of Scroll through channels and push SEL to select (when blue LED is flashing) the BM-A1-64DANTE. If no channels are routed to the monitor speakers (i.e., no blue Channel Select SEL/...
When Panel Description” on page 7). pressing the CLR button it will flash. Once the CLR button stops flashing the monitor mix is cleared. BM-A1-64DANTE User Manual v1.1 Bel Digital Audio Ltd...
PSU 2 PSU 2 Maximum Volume PSU Status The BM-A1-64DANTE comes as standard with +Vol 0 power supply redundancy. The status of PSU 1 and PSU 2 is provided on the front panel display. If green, the status of the power supply is good. When the...
482 x 200 x 44 (mm) / 19” x 7.87” x 1.73” [1U] (with rack ears fitted) Weight 2.75 kg / 6lbs Specifications and information contained in this manual are subject to change at any time without notice. BM-A1-64DANTE User Manual v1.1 Bel Digital Audio Ltd...