Initial Setup; Programming A Personal Passcode - First Alert 2077DF Operations & Installation Manual

https://www.supplychimp.com/

Initial Setup

InItIAl SetuP
emergencY overriDe keY uSe
Remove override key lock cover.
1
Insert key turn clockwise and hold.
2
Rotate handle clockwise then pull door open.
3
1 2
If the lever handle will not rotate clockwise after the key is turned, then rotate the lever
handle slightly counterclockwise until it stops, then rotate clockwise again to open.
The override key is used to gain access to the safe to change batteries or if the fingerprint
lock fails to operate. This key should be stored in a secure place away from your safe.
BatterY inStall
Remove battery cover.
1
Install four (4) AA batteries. Make sure to install them facing the proper direction.
2
Replace the battery cover.
3
When installed correctly, a red light will flash on the digital keypad.
4
1 2
2
AA
+
AA
+ - + -
- + - +
AA AA
3
3
ImPortAnt
3
AA +

ProgrAmmIng A PerSonAl PASScode

Open the safe door.
1
Press the reset button on the inside edge
2
of the door closest to the hinges.
When the safe is ready to be programmed,
3
you will hear a beep and a light
will flash on the keypad.
Enter your new three to eight (3-8) digit
4
passcode followed by 'A' or 'B'.
The light will once again flash and
5
you will hear a beep.
oPening Your Safe with the Digital keYPaD
Enter new code: 3-8 digits followed by the 'A' or 'B' key.
1
Ready light flashes along with a beep.
Rotate handle clockwise then pull door open.
2
1
4
Programming Personal Passcode
2
3
Beep
2
4
4