Installing The Power Recorder At A Facility; Work Flow - Fluke 1750 Getting Started Manual

1750
Getting Started Guide
5. Start Power Analyze on your PC by choosing Start >All Programs
>Fluke >Power Analyze >Power Analyze or double-click the Power
Analyze icon
6. After the installation is complete, please take a few minutes to complete
your product registration. You can register quickly online (preferred) at
http://register.fluke.com
provided on the form. Product registration is very important since it allows
you to get free software updates and helps us provide you with the fastest
and most efficient technical support.
You may need to change your Windows firewall settings to allow the
program FPA.exe to use ports 18571 (TCP) and 18572 (UDP). For
more on changing firewall settings, refer to
http://support.microsoft.com.

Installing the Power Recorder at a Facility

This section describes the steps you need to take to set up the Recorder at a
facility and begin a recording session.

Work Flow

There are three distinct stages for a recording session.
•
Setup
Setup, hookup, and verification of connections and measured signals. This
is when you will want to clear the Recorder memory (not required, but
best practice because data download when finished only contains your
new data). This is a good time to change any recorder settings. Edit the
measurement description now or after downloading the measurement data
and insert annotations and/or an optional START mark into the recorded
data stream. Annotations are messages or notes you insert into the data
stream during a recording session.
•
Interim checkup, mid-recording session
At this time, you may want to re-check all the live input signals, and
download the data recorded since the beginning of the recording session.
This does not interfere with ongoing recording in any way. Annotation
capability is always available during the recording session.
12
on your desktop.
or you can print the form and fax it to the number
Note