Honeywell HWB1052 Series Owner's Manual page 5

Direct sunlight may also cause algae to grow inside
your water bottle that may later cause product
malfunction.
DO NOT locate the unit in areas where the temperature
may fall below freezing (32º F / 0º C).
Allow 6 inches of space between the unit and the
wall, to allow for proper air circulation to cool the
compressor.
CAUTION: To prevent accidental tip hazard, the water cooler must be securely anchored
Please follow the instructions to load the water bottle before plugging the unit to the
power source.
Make sure the hot and cold water power switches are in the OFF position before plugging
the unit to the power source.
Do not use an adapter plug with this unit.
electrician or service technician install an outlet near the appliance.
Plug the unit into an exclusive properly installed grounded wall outlet. Do not cut or
remove the third (ground) prong from the power cord under any circumstances. Any
electrician.
ATTENTION:
If you do not plan to use the water heating function for more than three days,
we recommend that you turn off the hot water power switch.
Turn ON the hot water switch, wait a couple of
minutes and turn ON the cold water switch. Allow
the unit to reach the minimum cold and hot water
temperatures. This will take approximately 45
minutes and the Indicator Lights will turn OFF. (Fig. 4)