4.1 Accessing the Web Configuration Page
The HG552d provides simple and easy-to-use Web configuration pages, through which
you can check and configure the working parameters of the HG552d.
Before you log in to the Web configuration page of the HG552d, make sure the setting
requirements of the PC as listed in Table 4-1 are met.
Table 4-1 Requirements on PC settings
Item
Network protocol
IP address and subnet mask of
the PC
Internet Explorer
To log in to the Web configuration page, do as follows:
Step 1
Start the Internet Explorer on the PC.
Step 2
Enter http://192.168.1.254 in the address bar of the Internet Explorer, and then press
Enter .
The Login dialog box is displayed.
Step 3
Enter the name and password in the Login dialog box, and then click OK .
By default, the user name and password is operator and justr34d.
4.2 Restoring Default Settings
You can quickly restore the default settings of the HG552d by pressing the RESET
button on the rear panel. To restore the default settings, press and hold the RESET
button for over six seconds after the HG552d is powered on, and then release the button.
In addition, you can restore the default settings of the HG552d through the Web-based
configuration utility. To restore the default settings through the Web-based configuration
utility, do as follows:
Step 1
Log in to the Web-based configuration utility.
Step 2
Choose Maintenance > Device in the navigation tree.
4
Functions Introduction
Requirement
Enable the TCP/IP.
Select Automatically obtain an IP address .
Do not use the proxy server.
14
Functions Introduction