Advertisement
DLG-1000
13.Glue the aileron servo
15.Aileron pushrod
17.Aileron connection as picture.
19.Wing fixed screw
14.Seal the routing place with transparent
tape.
16.Connect the servo to aileron pushrod
and fixed with screw by screwdriver.
18.Cross the aileron servo into the routing
hole of fuselage.
20.Tighten the screw by screwdriver after
wing installed
21.Y Harness
23.Receiver
25.3A UBEC
26.Connect the receiver to the UBEC
DLG-1000
22.Connect the aileron servo wire to
Y harness
24.Insert all servo wires into the receiver
27.Place in order after the equipment
connection
Advertisement
