Summary of Contents for Techone DLG-1000
- Page 2 DLG-1000 DLG-1000 1.Wing 2.Stabilizer 3.Canopy Cover 4.Fuselage and rudder Item no.: 0880009 1.Easy installation,there is nothing but only need to install the vertical wing fences. 2.The spinner part and gripper have been used the perfect anti-resistance design. 3.The good and safe design of servo location.
- Page 3 DLG-1000 DLG-1000 8.Put the servo into the slot on fuselage,and fixed with screw. 3.Elevator Wire length 90MM, 3.7G Servo and accessories. 9.Rudder pushrod 4.Insert and screw the servo into the slot 5.Elevator tail pushrod on fuselage by screwdriver. 10.Cross the pushrod into carbon tail rod of fuselage and install it on the adjuster and rudder servo horn, then fixed with screw,and make sure to keep the rudder in the same horizontal line.
- Page 4 DLG-1000 DLG-1000 13.Glue the aileron servo 22.Connect the aileron servo wire to 14.Seal the routing place with transparent 21.Y Harness Y harness tape. 24.Insert all servo wires into the receiver 23.Receiver 15.Aileron pushrod 16.Connect the servo to aileron pushrod and fixed with screw by screwdriver.
- Page 5 DLG-1000 DLG-1000 28.Lipo battery 2S 350MAH 30.Throwing carbon rod 31.Reserve two mounting holes on left and right wing tip, consumers can choose the suitable hole they think, then bond with glue 29.Lock the plastic canopy cover with screw after the equipment connection...
- Page 6 DLG-1000 DLG-1000 Item No.088701-Wingspan Item No.088702-Vertical stabilizer Item No.088704-Fuselage Item No.088710-3A UBEC Item No.088703-Horizontal stabilizer Item No.088711-350mah 7.4V lipo20c Battery...
- Page 7 DLG-1000 DLG-1000 Item No.088705-Accessory pack Item No.088707-3.7g Servo 220mm Item No.088708-3.7g Servo 90mm Item No.088706-PP decal Item No.088709-3.7g Servo 80mm...
- Page 8 DLG-1000 DLG-1000...