Table of Contents
Advertisement
Getting Started
Hardware Installation
Please be sure to follow the steps in the sequence outlined below. Failure to do so could result in
improper operation or damage of your ADSL wireless modem.
Step 1: Connect a RJ-11 cable from wall phone jack feed to the connector "LINE" on the back of
the modem.
Step 2: Connect the AC adapter to the modem by inserting the barrel-shaped connector into the
mating power connector on the back of the modem, and plug in the adapter to a wall outlet
or a power strip.
Step 3: Connect any LAN port on the back of the modem with a UTP cable, and other end of
UTP cable directly link to RJ-45 port of your PC's network card.
Step 4: Power on your PC and modem, now you are ready to configure PC.
Note: You also use wireless interface to configure your modem, don't need step 3 to do and then
directly proceed step 4, but make sure your wireless card has installed driver properly.
Caution: Please do not power on your PC and modem before connecting
steps are finished as mentioned above.
PARADYNE ADSL Wireless Modem Router Manual
3
Page
Advertisement
Table of Contents
