Table of Contents
Advertisement
VRX240comb
4/8/99 8:45 PM
36 Rerecording (Tape Duplication)
1. Audio cable from AUDIO OUT Jack of
VCR 1 to AUDIO IN Jack of VCR 2
VCR 1
Playing VCR
AUDIO
OUT
IN
VIDEO
Audio and Video cables are not supplied.
1
Make the connections shown above.
2
VCR 1 will play your tape. Put a prerecorded tape in VCR 1.
3
VCR 2 will record your tape. Insert a blank tape in VCR 2. The
VCR must be in VCR position. (The VCR light will appear on the display
panel. If it does not, press the VCR/TV button once.)
4
Turn on the TV and set it to channel 03 or 04, whichever
channel the CH3/CH4 switch on VCR 2 is set to.
5
Point the remote control at VCR 2. Press Number but-
tons 0, 0 to select Line Input. A/V IN will appear on-
screen.
6
Use the SPEED button to select SP, LP, or SLP at VCR 2.
7
Press the PLAY button on VCR 1 and the REC(ord)/OTR
button on VCR 2 at the same time.
To stop recording, press the STOP/EJECT button on VCR 1, then
press the STOP/EJECT button on VCR 2.
Page 36
ANT
IN
OUT
CH3
CH4
2. Video cable from VIDEO OUT Jack
of VCR 1 to VIDEO IN Jack of VCR 2
VCR 2 - Recording VCR
AUDIO
OUT
VIDEO
• Unauthorized recording of copy-
righted television programs, video
tapes, or other materials may
infringe on the rights of copyright
owners and violate copyright laws.
• These instructions show you how to
copy tapes using two VCRs like
yours. Different VCRs may operate
differently.
ANT
IN
IN
OUT
CH3
CH4
3. RF coaxial
cable from VCR's
OUT Jack to TV's
ANTENNA IN
Jack
Helpful Hints
Advertisement
Table of Contents
