Location Of Parts And Replacement Parts List; The Following Symptoms Are Not Trouble; Troubleshooting - Panasonic NA-F60A6 Service Manual

7. TROUBLESHOOTING

7.2 The following symptoms are not trouble.

Symptoms
Machine begins filling water in
the middle of the wash.
The water level is too high for
the amount of laundry being
washed.
The water level is too low for the
amount of laundry being
washed.
Midway during spinning, the
operation suddenly changes to
rinsing.
Water does not flow through the
lint filter. Double Cascade does
not operate.
Softener spills out from softener
drawer.
During draining, the laundry and
the spinner rotates with irregular
movements.
The buttons do not work.
If you start with the rinse cycle,
the tub is not filled with water.
Washing machine does not run
at all.
• When the laundry amount is large at the HIGH water level, the machine
sometimes fills automatically. When level goes down, the machine fills
automatically.
• When the laundry is already soaked with water before the wash is
started, or if there is water in the tub before the wash is started, the
water level will sometimes be higher.
• With light laundry made of synthetic or blended fabric, the water level will
sometimes be lower.
• When the laundry is unbalanced during spin, rinsing and automatic
correction of unbalanced laundry will begin. Later spinning will return to
normal condition.
• When the water level is set to very low, water sometimes will not flow
through the lint filter. Double Cascade does not operate when these
settings have been selected.
• Keep the level of the softener indicated to prevent the softener from
flowing immediately.
• If you close the softener drawer forcefully, softener may spill out of the
drawer.
• To suppress soap suds build-up, the washing tub turns slowly and
quickly.
• Only the [WATER LEVEL] button is available after the machine begins
washing.
• To change the setting, press the [START/HOLD] button or press the
[POWER OFF/ON] button and reconfigure the setting.
• When there is water in the tub, the operation starts with the draining.
After spin cycle is finished, the tub will be filled with water.
• Check if there is power failure.
• Check if the power fuse has blown out or the breaker is actuated.
• Check if the power plug is plugged in thoroughly.
• Check if the "power switch" has been pressed.
• Has the water faucet been turned on?
• Check if the [START/HOLD] button has been pressed.
• Has the machine been programmed under [RESERVE] timer?
15
Causes