Installing The Logs - Superior VRE4336ZEN Installation And Operation Instructions Manual

INSTALLING THE LOGS

• LOGS GET VERY HOT AND WILL REMAIN HOT UP TO ONE
HOUR AFTER GAS SUPPLY IS TURNED OFF. HANDLE ONLY
WHEN LOGS ARE COOL. TURN OFF ALL ELECTRICITY TO
THE APPLIANCE BEFORE YOU INSTALL GRATE AND LOGS.
• THIS APPLIANCE IS NOT MEANT TO BURN WOOD. ANY
ATTEMPT TO DO SO COULD CAUSE IRREPARABLE DAMAGE
TO YOUR APPLIANCE AND PROVE HAZARDOUS TO YOUR
SAFETY.
• THE SIZE AND POSITION OF THE LOG SET WAS ENGINEERED
TO GIVE YOUR APPLIANCE A SAFE, RELIABLE AND ATTRAC-
TIVE FLAME PATTERN. ANY ATTEMPT TO USE A DIFFERENT
LOG SET IN THE FIREPLACE WILL VOID THE WARRANTY
AND WILL RESULT IN INCOMPLETE COMBUSTION, SOOT-
ING, AND POOR FLAME QUALITY.
• VOLCANIC STONE WITHIN THE BURNER CAN "POP" FOR THE
FIRST FEW FIRES. WIND BORNE DEBRIS MAY ALSO ENTER
THE FIREPLACE INEXPEDIENTLY. IN HIGH WIND CONDI-
TIONS, OPERATE THE APPLIANCE WITH THE SCREENS OR
DOORS CLOSED.
• NEVER OPERATE THE FIREPLACE WITHOUT THE VOLCANIC
STONES IN THE BURNER PAN. PROLONGED USE WITHOUT
THE ROCK IN PLACE WILL OVERHEAT THE PAN AND CAUSE
THE FIREPLACE TO SHUTOFF AUTOMATICALLY.
After verifying that the fireplace operates properly, replace the cover and
set the bottom refractory components in place.
Use two (2) bags of volcanic stone to fill the bottom of the burner tray
to completely cover the burner tube. Level the volcanic stone evenly.
Place the rear log approximately centered as shown in Figure 15.
Place the base log approximately as shown in Figure 16.
The remaining logs can be placed across the rear and base log ap-
proximately as shown in Figure 17. The exact position of these logs is
not critical. Due to the nature of an outdoor environment, the flame will
never be strictly controlled. You may need to reposition the logs to get
the effect you find most desirable.
12
WARNING
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Rear Log
Figure 15
Base Log
Figure 16
Top Center Log
Top Left Log
Figure 17
Top Right Log