Table of Contents
Advertisement
FCC STATEMENT:
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1) This device may not cause harmful interference, and
2) This device must accept any interference received, including interference
that may cause undesired operation.
WARNING: Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
reorient or relocate the receiving antenna, increase the separation between the equipment
and receiver, connect the equipment into an outlet on a circuit different from that to which
the receiver is connected, consult the dealer or an experienced radio/TV technician for help.
RF WARNING STATEMENT:
The device has been evaluated to meet general RF exposure requirement. The device can be
used in portable exposure condition without restriction.
IC STATEMENT:
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
1) This device may not cause interference, and
2) This device must accept any interference, including interference that may
cause undesired operation of the device.
PRODUCT USE AND PROTECTION:
Read and follow all instructions. Use only as intended.
The ECOXGEAR Bluetooth speaker is intended to be used indoors or outdoors and in land
or water environments. The speaker has been tested to IP68 waterproofing standards, which
means the speaker can be submerged in up to 6 feet of water for 30 minutes without any
damage. However, the speaker is NOT intended for constant underwater use.
Always make sure the cap(s) / covers(s) are clean, free from sand or debris, and correctly
fitted. The speaker will only meet IP68 ratings if all rubber seals, gasket(s), and cover(s) /
cap(s) are in place. If you notice a muffling of audio after submersion, gently shake the unit
to clear excess water. If your speaker is exposed to salt water, clean it thoroughly after use
with fresh water.
The USB cables, power adapters, and unit with an improperly fitted cap are NOT waterproof.
To prevent fire or shock, do NOT attempt to charge this unit if it is wet or you suspect
water has entered the unit. In this situation, please return the unit to Grace Digital for a free
assessment. If we have found that the unit has carried water, we will repair or replace the unit
free of charge.
Advertisement
Table of Contents
