Table of Contents
Advertisement
Safety instructions
Care
– Read the instruction manual and installation instructions and all other information enclosed with the washing
machine and act accordingly.
– Retain the documents for subsequent use.
Risk of electric shock
– Never pull the cable to disconnect the mains plug.
– Never insert/disconnect the mains plug with damp hands.
Danger to life
For worn-out appliances:
– Disconnect the mains plug.
– Sever the mains cable and discard along with the plug.
– Destroy the lock on the washing machine door. This will prevent children from
locking themselves in and risking their lives.
Danger of suffocation
– Keep packaging, film and packaging parts out of the reach of children.
Risk of poisoning
– Keep detergents and care products out of the reach of children.
Risk of explosion
– Items of laundry pretreated with cleaning agents containing solvents, e.g. stain
remover / cleaning solvent may lead to an explosion after being loaded into the
1. Pull the drawer out, press down the insert and fully remove the drawer from the housing.
washing machine.
2. To remove the insert: press the insert upwards from below with your finger.
Rinse items of laundry thoroughly by hand beforehand.
3. Clean the detergent dispenser tray and insert with water and a brush and dry it. Also remove
Risk of injury
– The washing machine door can become very hot.
4. Attach the insert and engage (connect the cylinder to the guide pin).
– Be careful when draining hot detergent solution.
5. Push in the detergent drawer.
– Do not climb onto the washing machine.
– Do not lean on the open washing machine door.
– Do not reach into the drum if it is still rotating.
– Be careful when opening the detergent drawer while the machine is in operation.
Consumption values
depending on model
Programme
Programme
Load
Electricity**
Water**
duration**
Cottons 20 °C
7 kg
0,31 kWh
72 l
2 ¾ h
Cottons 40 °C
7 kg
0,85 kWh
72 l
2 ¾ h
Cottons 60 °C
7 kg
1,21 kWh
72 l
2 ¾ h
Cottons 90 °C
7 kg
2,01 kWh
77 l
3 h
Easy-Care 40 °C
3 kg
0,64 kWh
56 l
1 ¾ h
Mix 40 °C
3 kg
0,46 kWh
36 l
1 ¼ h
Delicate / Silk 30 °C
2 kg
0,24 kWh
37 l
¾ h
1. Turn the programme selector to Off and disconnect the mains plug.
2. Drain the detergent solution
/
Wool 30 °C
2 kg
0,22 kWh
47 l
¾ h
3. Pull the emergency release downwards with a tool and release.
Annual energy
Annual water
Programme
Additional function
Load
consumption
consumption
Information on the display panel
Cottons 40 / 60 °C
EcoPerfect*
3,5/7 kg
165 kWh
10686 l
* Programme setting for testing and energy labelling in accordance with EU directive 2010/30/EU with cold water (15 ºC).
F: 16
** The values deviate from the indicated values depending on water pressure, hardness, and inlet temperature, ambient tem-
perature, type, amount and soiling of the laundry, detergent used, fluctuations in the power supply and selected additional
F: 17
functions.
F: 18
F: 21
F: 23
8
7
– Risk of electric shock.
Maintenance
Disconnect the mains plug.
– Risk of explosion. No solvents.
Before washing for the first time
Detergent solution pump
Do not load any laundry into the machine. Turn on the tap. Add the following to compartment II:
Turn the programme selector to Off and disconnect the mains plug.
– approx. 1 litre water
1. Open and remove the service flap.
– detergent (dosage according to the manufacturer's instructions for light soiling and the appropriate degree of water
hardness)
Easy-Care 60 °C and select
Start/Reload. At the end of the programme, turn
Set the programme selector to
the programme selector to Off.
2. For models with a drainage hose: Remove the drainage hose from the
Machine housing, control panel
retainer and pull it from the housing. Remove the container.
Remove the sealing cap, allow the detergent solution to flow out.
– Wipe with a soft, damp cloth.
Replace the sealing cap and place the drainage hose in the retainer.
– Do not use any abrasive cloths, scourers or cleaning agents (stainless steel cleaners).
– Remove detergent and cleaning agent residue immediately.
– Do not clean with a jet of water.
2* For models without a drainage hose: Carefully unscrew the pump cover
Cleaning the detergent drawer and housing...
until the detergent solution begins to flow out. When the service flap is
half full, close the pump cover and empty the service flap. Repeat the
... if it contains detergent or fabric softener residues.
above steps until all the detergent solution has completely drained out.
3. Carefully unscrew the pump cover (residual water).
4. Clean the interior, pump cover thread and pump housing (the impeller in
any detergent or fabric softener residues in the housing.
the detergent solution pump must rotate).
5. Replace the pump cover and screw it tightly.
6. Place the service flap back on and close.
Leave the detergent drawer open so that any residual water can evaporate.
To prevent unused detergent from flowing straight into the drain during the next wash:
Washing drum and rubber seal
Pour 1 litre of water into compartment II and start the
Wipe the inside of the rubber seal dry with a cloth. Leave the washing machine door open so that the drum can dry out.
Drainage hose at the siphon
Rust stains - use chlorine-free cleaning agent, not steel wool.
Turn the programme selector to Off and disconnect the mains plug.
Descaling
Ensure there is no laundry in the machine
1. Loosen the hose clamp, carefully remove the drainage hose (residual
Descale the appliance according to the descaler manufacturer's instructions. This should not be necessary if the
water).
correct dosage of detergent is used.
2. Clean the drainage hose and siphon connecting piece.
Emergency release, e.g. in the event of a power cut
3. Reattach the drainage hose and secure the connection with the hose
clamp.
The programme continues to run when the power has been restored. However, if the laundry has to be removed, the
washing machine door can be opened as follows:
Filter in the water supply
Risk of scalding.
Risk of electric shock!
The detergent solution and laundry may be hot. If possible, leave it to cool down.
Do not immerse the HydroSafe safety device in water (contains an electric valve).
Do not reach into the drum if it is still rotating.
Do not open the washing machine door if water can be seen through the glass.
Reduce the water pressure in the supply hose:
page 10.
1. Turn off the tap.
2. Select any programme (apart from
Washing machine door can then be opened.
3. Choose
Start/Reload. Let the programme run for approximately
40 seconds.
4. Turn the programme selector to Off. Disconnect the mains plug.
depending on model
Clean the filter:
Close the washing machine door properly; laundry may be caught.
1. Depending on model:
Disconnect the hose from the tap.
Open the tap completely, supply hose kinked or trapped;
Clean the filter using a small brush.
Clean the filter
page 10, Water pressure too low.
Detergent solution pump blocked; Clean the detergent solution pump
page 10. Drainage hose / waste pipe
and/or for Standard and Aqua-Secure models:
blocked; Clean the drainage hose at the siphon
page 10.
Motor fault. Call customer services.
Remove the hose on the rear of the appliance,
Remove the filter with pliers and clean.
Water in the base tub, appliance leaking. Call customer services.
2. Connect the hose and check for leaks.
9
– Risk of scalding.
What to do if ...
Allow the detergent solution to cool down.
– Turn off the tap.
Water is leaking out.
– Attach/replace the drainage hose correctly.
– Tighten the screw connection of the supply hose.
No water supply.
–
Start/Reload not selected?
Detergent not dispensed.
– Tap not turned on?
– Filter blocked? Clean the filter
– Supply hose kinked or trapped?
Washing machine door
– Safety function active. Programme stopped?
cannot be opened.
–
(without final spin) selected?
– Can be opened by emergency release only?
Programme does not start. –
Start/Reload or
(Finished in) time selected?
– Washing machine door closed?
– Childproof lock active? Deactivate
Detergent solution is not
–
(without final spin) selected?
drained.
– Clean the detergent solution pump
– Clean the waste pipe and/or drainage hose.
Water not visible in the
– Not a fault - water below the visible area.
drum.
Unsatisfactory spin result.
– Not a fault - the unbalanced-load detection system has cancelled
Laundry wet/too damp.
the spin cycle because of uneven distribution of the laundry.
Distribute small and large items of laundry evenly inside the drum.
–
(Easy-Iron) selected?
– Selected speed too low?
The programme duration
– Not a fault – the programme sequence is optimised for the
changes during the wash
particular wash process. This may result in changes to the
cycle.
programme duration in the display field.
Empty programme.
Spin cycle performed
– Not a fault - unbalanced load detection system adjusts the
several times.
imbalance.
Residual water in the
– Not a fault - the action of the care product is not affected.
compartment for care
– Clean the insert if necessary
products.
Odour formation in the
– Run programme
Cottons 90 °C without laundry. Use standard
washing machine.
detergent.
Status display
(Wash)
– Too much detergent used? Mix 1 tablespoon of fabric softener
flashes.
with ½ lit,re of water and pour into dispenser II (not for outdoor
Foam may be coming out
and down-filled textiles!).
of the detergent drawer.
– Reduce the detergent dosage for the next wash cycle.
Intense noise formation,
– Are the appliance feet fixed?
vibrations and "wandering"
Secure the appliance feet
during the spin cycle.
– Transportation safety devices removed?
Remove the transportation safety devices
instructions.
Noises during spin and
– Clean detergent-solution pump
Spin /
Empty).
drain cycles.
Display panel/indicator
– Power cut?
lamps do not function
– Fuses triggered? Reset/change the fuse.
during operation.
– If the fault occurs repeatedly, call customer services.
Programme sequence
– Not a fault - unbalanced load detection system adjusts imbalance
longer than usual.
by repeatedly distributing the laundry.
– Not a fault - foam detection system active - adds an additional
rinse cycle.
Detergent residues on the
– Occasionally, phosphate-free detergents contain water-insoluble
laundry.
residues.
– Use the
Rinse cycle or brush out the laundry after washing.
If you cannot correct a fault yourself (switching on/off) or a repair is required:
– Turn the programme selector to Off and remove the mains plug from the socket.
– Turn off the water supply and call customer services
10
page 10.
page 4.
page 3, 4.
page 9.
page 5.
page 3, 4.
page 10.
page 5.
page 5.
page 9.
Washing machine
Installation instructions.
Installation
WM14E469BY
page 10.
siemens-home.com/welcome
en Washing machine
operating instructions
Observe the safety instructions on page 8.
Read these instructions and the separate installation
instructions before operating the washing machine.
Installation instructions.
11
Register
your
product
online
Advertisement
Table of Contents
