Reducing Picture Disturbance ('Optimizing The Modulator'); Switching Off The Modulator - Philips VR200/58 Operating Instructions Manual

Reducing picture disturbance ('optimizing
the modulator')
You may experience picture disturbance if you have not used
a scart cable to connect your video recorder and TV. This is
because another TV station in your reception area may
already be using UHF-channel CH36 or 591MHz.
a
Make sure that there is no cassette in the video recorder.
With the video recorder switched off hold the
button for a few seconds until the modulator frequency,
for example, 'G591' (591 Mhz or channel 36) appears on
the video recorder display. The video recorder will then
transmit a test picture channel or frequency.
MODULATOR
------------------------
-/+
ON/OFF
b
Change the modulator frequency with the
P q button.
c
Confirm the new modulator frequency with the
button.
d
Tune in the TV set to this channel or frequency.
e
To end, press the TV/STANDBY m
D If the picture or sound quality is poor, you may have
selected the wrong TV system. At step
the TV system 'G591' for PAL-B,G or 'K591' for
SECAM-D,K, using the
switch the modulator on again, hold the
button, until 'G591' (Modulator
CLEAR (CL), y
switched on) appears on the display.
f
To end, press the
TV/STANDBY m
SYSTEM
591 G
G/K SELECT
CL OK
P r or
OK
button.
a
, select
button. If you want to
SELECT
button.

Switching off the modulator

If you cannot clear picture or sound interference, you can
switch off the built-in modulator.
You should only do this if you have connected the video
recorder to the TV set with a scart cable. 'Connecting VCR
without scart cable' is not possible when the modulator is
switched off.
a
Switch on the TV set and select the programme number
for the video recorder.
b
Make sure that no cassette is in the video recorder.
Press the button for several seconds, until, for
SYSTEM
example, 'G591' appears on the video recorder display.
c
Hold the
CLEAR (CL), y
off) appears on the video recorder display. If you want to
switch the modulator on again, hold the
button, until 'G591' (Modulator switched on) appears on
the display.
d
To end, press the TV/STANDBY m
button, until 'MOFF' (modulator
CLEAR (CL), y
button.
21