Turning On Your Vcr 11 - Philips SV2000 SVZ122 Owner's Manual

Philips svz122 video cassette recorder owner's manual

Hide thumbs

Table Of Contents

Table of Contents

SVZ122(H1680).QX33

4/6/99 9:42 PM

Before turning on your VCR, make sure there are batteries in

the remote control and the VCR and TV are connected (see

pages five - 10).

You can not set up channels if you are using a Cable Box/DBS.

The instructions on this page only work when you turn on the

VCR for the first time. If there is a power failure or if the VCR

is unplugged for more than one minute, you may need to repeat

the instructions on this page.

Press the POWER button. The POWER light and the VCR/TV

light will appear.

Turn on the TV. Set it to the same channel as the

CH3/CH4 switch on the back of the VCR. The menu shown

below will appear.

LANGUAGE SELECT

ENGLISH

ESPAÑOL

Press the PLAY button or the STOP button to select

ENGLISH or ESPAÑOL. [ON] will appear beside your choice.

Press the F.FWD button or the MENU button. TUNER SET

UP will appear on-screen.

TUNER SET UP

Press the MENU button, the F.FWD button, or the

REWIND button to begin automatic channel setup.

TUNER SET UP will flash on-screen. The VCR will memorize all

available channels, so when you use the CHANNEL o/p buttons,

you'll only scan through channels that you receive. When channels

are set up, the TV will go to the lowest channel available.

(If you try to set up channels when there is no antenna or cable

connected to the VCR, programming will appear to take place.

Eventually, TUNER SET UP will appear on-screen steadily, and

channel programming will stop. Connect an antenna or cable to

the VCR, then press the MENU button, the F.FWD button, or the

REWIND button again. Channel programming will begin again.)

Page 11

[ON]