Operation - Westinghouse PT50350 Instruction Manual

Installing the side handle
The side handle should always be used during operation. Screw the handle into the top,
left or right of the grinder housing .It s determined by your need.
• Adjusting the wheel guard
It's offered to protect your hands to contact wheel.
Before adjusting, power supply shall be disconnected from tool!
• ON-OFF Switch To start:
1. To turn your angle grinder"ON", push the on-off switch forward.
2. To turn the tool"OFF",release the on-off switch,which is spring-loaded,and it will
return to the "0" position automatically.
For continuous operation:
3. Push the on-off switch forward to the ON position and press the front of the button
down until the switch clicks into position.
4. To unlock the switch and turn the tool OFF, press the rear of the button.
• Installing and removing the grinding wheel disc To remove:
1 Press the spindle lock button.
2 Loosen the spindle lock nut by turning the nut counterclockwise with the wrench.
3 Remove the threaded outer flange.
4 Remove the grinding wheel from the spindle.

OPERATION

1. ON-OFF switch
2. Lock button
3. Side handle
4. Operating handle
5. Gear housing
6. Wheel guard
7