Address Decoder Removal - Scientific Atlanta 8500 SERIES Operator's Manual

5. 3. 2. 3
Step 1.
Step 2.
Step 3.
Step 4.
Step 5.
Step
6.
5.3. 2. 4
Step 1.
Step 2.
Step 3.
Step 4.
Step 5.
Step 6.
5-8
Address Receiver Removal (figure 5-3).
Straighten the cable straps to allow removal of cable.
Cut cable tie.
Unplug connector from address decoder.
Unplug phono plug from up/down converter.
Straighten the three twist tabs.
Lift out address receiver module.
Address Decoder Removal (figure 5-4).
Be sure you are working on a grounded metal table
or work bench; see CAUTION given under paragraph
5, 3. 2. 1.
Unplug upper connector plug from board.
Unplug connector plug from middle area of control boa rd.
Straighten cable straps to allow removal of cable.
Cut cable tie.
Straighten the three twist tabs.
Lift out address decoder module.
Note
On early production units a ground wire was connected
from the module to the regulator. You m'.ist also un-
solder this wire at the regulator to completely remove
the module.
33T056A