Advertisement
Problems caused by faulty connection will invalidate the warranty.
2. LS. The loudspeaker output terminal.
Upper one is Red (+), bottom one is RED (-).
Both are Red because this is a balanced or symmetrical amplifier.
3. Input. Two inputs: upper one is the a-symmetrical (single-ended) one with a RCA-cinch
chassis connector. The bottom one features a XLR connector for balanced or symmetrical
use. A switch is provided inside the amplifier, to select the input desired. Standard the RCA-
cinch input is connected.
This switch can only be accessed by an authorized Van Medevoort Service Center.
4. DC control. DC control can only be used with DC control output on a Van Medevoort Pre or
Main amplifier(s). One can only switch into STANDBY or ON, via the Van Medevoort Remote
Control. DC out on the Power Amp can be used to switch the second (or more in case of multi
channel) vM Power Amplifier via the DC in.
5. IEC-USA Power Chassis Connector. To be connected with the proper wall socket, which must
be earthed or grounded. Every Van Medevoort product is optimized for your country's electrical
standards. e.g. 230V-50Hz or 115V-60Hz. This cannot be changed. Please check that your
product is set to the correct voltage setting BEFORE connecting to an AC power outlet.
5
vM PA471 MONO POWER AMPLIFIER
Controls
Precautions
Connections
Maintenance and advice
Technical Specifications
2
3
4
5
Advertisement
