Parts - SEMAK VB200 Operation And Warranty Booklet

PARTS

The VB200/250 experienced a parts modification in 2008. The model you have can be determined
by the drive shaft with the current model having a flat spline of approximately 20mm.
This range of electroportables has been exclusively designed to make the assembling and
disassembling of all the parts easier, especially of those that have to be handled frequently because
of cleaning and maintenance purposes.
For the assembling or disassembling of the parts, first place the machine in the vertical position,
with the blade looking up.
The blade is inserted into the lowest extremity of the transmission shaft with the help of a screw.
For assembling and disassembling, the operator only needs a screwdriver. To handle the blade in a
safe way, hold it always with a safety glove or with a thick cloth (Step 1, Figure 1).
The blade guard is attached to the tube by a thread. To detach it, turn it in the direction of the
arrow (Step 2, Figure 1).
Once the blade out of the guard, the transmission shaft, the bearing bush and the joints will be free
to be taken out (Step 3, Figure 1).
To reassemble the set, insert the transmission shaft with the bearing bush and the inner joint in the
tube till it clicks. Press the bearing bush. If it does not enter totally (keeps about 10 mm out), turn
and push the shaft following the Step 4, Figure 1 till the bearing bush is totally in. To finish, thread
the guard with the outer joint in the tube and follow Step 1 in the opposite way of the
disassembling.
Step 1
4
Figure 1
REMARK: To thread the screw, align the cavity of the shaft with that of the blade and place the blade
on the shaft extremity level (Figure 2).
Step 2
blade guard
outer joint
inner joint
bearing bush
transmission
shaft
Step 3 Step
Page | 9