Assembling The Grass Bag - Toro 20377 Operator's Manual

3. Carefully pour about 3/4 of the engine capacity of oil
into the oil-fill tube.
4. Wipe the dipstick clean with a clean cloth.
5. Insert the dipstick into the oil-fill tube, but do not
screw it in, then remove the dipstick.
6. Read the oil level on the dipstick
•
If the oil level on the dipstick is too low, carefully
pour a small amount of oil into the oil-fill tube,
wait 3 minutes, and repeat steps
the oil level on the dipstick is at the correct level.
•
If the oil level on the dipstick is too high, drain
the excess oil until the oil level on the dipstick is
at the correct level; refer to
Oil (page 15).
Important: If the oil level in the engine is too
low or too high and you run the engine, you
may damage the engine.
7. Install the dipstick securely.
4

Assembling the Grass Bag

No Parts Required
Procedure
1. Slip the grass bag over the frame as shown in
Figure 8
(Figure 8).
3 through
Changing the Engine
g188681
1. Handle
2. Frame
Note: Do not slip the bag over the handle
2. Hook the bottom channel of the bag onto the bottom
of the frame
5 until
3. Hook the top and side channels of the bag onto the top
Figure 9. and sides of the frame, respectively
6
1
3
2
Figure 9
3. Grass bag
(Figure 10).
Figure 10
g027120
g027120
(Figure 9).
g027121
g027121
(Figure 10).