Setting Up The Universal Remote Control - Philips WVH111 User Manual

S U
ETTING UP THE
R C
EMOTE ONTROL
The Set Top Box remote control can replace as
many as four different remote controls. It may
operate some functions of your TV, VCR, Cable
Box, or amplifier/receiver.
With batteries in the Set Top Box remote con-
trol, follow the steps below to make the remote
control your other equipment. You will follow
the steps for each piece of equipment.
If your brand is not listed on pages 29-31, or if
the remote won't operate the equipment after
you finish steps 1-3, continue to use the remote
control originally provided for your TV, VCR,
Cable Box or amplifier/receiver.
Simultaneously press the SET button and
the device button of the device you want to con-
trol (TV, VCR, CABLE, or SAT/AUX). Release
both buttons.
Press the Number buttons to enter the
three-digit code for your brand of equipment.
Refer to the Code Lists on pages 29-31.
With your equipment turned on, test the
remote control by pressing the Channel + button
to switch your device to the next higher channel.
When the Channel +/- buttons on the remote
change the channels, your remote is programmed
correctly.
F
EATURES
NIVERSAL
( ' )
CONT D
28
S H
MART ELP
If there is more than one
code for your brand, try
each code until you find one that
works.
Remember to press the TV,
VCR, CABLE, or SAT/AUX but-
ton before using the remote to
control the TV, VCR, Cable Box,
or amplifier/receiver.