Table of Contents
Advertisement
3.3
Install
Press B on the remote control and wait a few
seconds to switch the receiver on.
The receiver is on: the LED is green.
The receiver is in standby mode: the LED is red.
During a software loading: the LED is blinking.
At the fi rst installation, the First Time
Installation window appears:
Highlight the Country fi eld using the arrow
key
.
Select the desired language using the arrow
key
or
.
Note
Read the information messages displayed on
the screen. They will help you to set the correct
values.
Highlight Postcode using the arrow key
Press OK and enter your postcode.
Then successively set the desired values. In
doing so, observe the following:
•
By using the arrow key
between the individual setting possibilities.
•
By using the arrow key
the displayed values.
•
Then highlight the OK fi eld using the arrow
key
, and press OK.
10
.
or , you switch
or , you change
The Automatic Search window is displayed:
If desired, change the values for the Start
and End Frequency using the arrow key
or
.
Note
The displayed values for the Start and End
Frequency can normally be maintained.
Using the arrow key
channels to be searched for: All channels or
channels that are Free to air only.
Then highlight the OK fi eld using the arrow
key
, and press OK to start the channel
search.
The window displayed provides information on
the progress of the channel search.
Note:
By pressing EXIT, you can stop the scan mode
at any time.
or
, you defi ne the
Getting started
Advertisement
Table of Contents
