Front Of The Unit (Dcw615) - Technicolor - Thomson DCW615 User Manual

Chapter 4: Additional Information
3
Power
Test
5 4
Link/Act
1 2

Front of the Unit (DCW615)

1. Power Indicates when the unit is on.
2. Test Indicates when the unit goes through its self-diagnosis mode during boot-up and
restart. It turns off upon successful completion of the startup sequence.
3. The LAN indicators
USB Indicates when the USB port is properly connected to your PC and active.
HPNA Indicates when the HPNA port is plugged in and ready to transfer data.
WLAN Indicates when the Wireless PC card is present.
Link/Act Indicates steady on when link is established and blinks when data is flowing
through the corresponding LAN port.
Full/Col Indicates steady at full duplex mode, off at half duplex mode, and blinks when
collisions are detected on the corresponding LAN port.
100/10 Indicates steady on when a successful 100Mbps connection is made through the
corresponding LAN port.
4. The WAN indicators
Cable-Link Indicates steady on when cable system initialization is complete and ready to
transfer data. Blinks when scanning for a downstream DOCSIS RF carrier.
Receive Blinks when user data is going through the cable modem to the PC.
Send Blinks when user data is going through the cable modem from the PC.
36
16096620 DCW615/25. 04 Addit
USB Link/Act 2 Cable-Link
HPNA Full/Col 1 Receive
WLAN 100/10 Send
1 2 3 4 Cable
Ethernet
3 4
36
Chapter 4
6/26/03, 10:45 AM