Quick Start; Powering Up; Removing The Lens Cap - Sony PDX10 Workshop Handbook

Quick Start Instructions For The Sony PDX-10
Follow the next Five Steps for a quickstart to recording.
1.USING THE POWER CORD
2.USING THE BATTERY
2. Press down the BATT tab (located just above the battery
compartment) and at the same time slide the battery upwards.
3.REMOVE THE LENS CAP
1. Open the DC cover located at the rear of the camera
(below the battery compartment).
2. Connect the DC end (small connector) of the power supply
to the DC input.
3. Connect the AC power cord to the power supply.
4. Connect to AC wall outlet.
1. Lift the viewfinder.
2. Slide the battery in a downward motion until you hear it
click into place.
For more information on
batteries see page 15
1. Lift the viewfinder
1. Locate the lens cap in front of the camera.
2. Squeeze gently on the tabs on either side of the lens cap
and pull off.
3. Secure cap to the hand strap on the side of the camera.
4. When finished taping place lens cap back over lens.
SONY PDX10 Handbook page 3
REMOVING THE BATTERY