Installation Requirements
Required Equipment
Hardware
EcoAir (P/N: PST6550)
•
EcoInsight/EcoSource (P/N: PST6000)
•
Voltmeter
•
Small Phillips screwdriver
•
Wire nut or electrical tape
•
Wire stripper
•
Wire cutter
•
Security screw wrench
•
Level
•
Two AA Batteries
•
Regulatory Compliance
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
FCC Notice
This equipment has been tested and found to comply with the limits for a class B digital device pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If the equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and the receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is
•
connected.
Consult the dealer or experienced radio/TV technician for help.
•
In order to maintain compliance with FCC regulations, shielded cables must be used with this equipment.
Operation with non-approved equipment is likely to result in interference to radio and TV reception. The user
is cautioned that changes and modifications made to the equipment without the approval of the manufacturer
could void the user's authority to operate the equipment.
To satisfy RF exposure requirements, this device and its antennas must operate with a separation distance of at
least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or
transmitter.
EcoWave Installation Guide
Installation Requirements
Revision 9
Page 2
Telkonet, Inc.
10200 W. Innovation Dr., Ste. 300
Milwaukee, WI 53226
(800) 380-9640
www.telkonet.com