Advertisement
DISASSEMBLY ADVICE
BACKPLATE 3
BACKPLATE COVER 26
CORDSET 4
BALL SWIVEL 5
Remove
Screw A
Remove
Screws B1, B2
FILLING DOOR 6
INLAY 7
OPERATION KNOBS 8
ELECTRONIC
CONTROLLER 9
Remove
Screw A
Remove
Backplate 3, 26
SLIDE UNIT 10
NEEDLE SET 11
TANK SEAL 12
HANDLE 13
SELF CLEAN BUTTONS 14
SPRAY NOZZLE ASSY 15
PUMP ASSY 16
Remove
Screw A
Remove
Backplate 3, 26
Remove
Inlay 7
Remove
Operation knobs 101, 102
Remove
Screws C1, C2
Remove
Slide Unit 103, 104
Remove
Needle set
105, 106, 107, 108, 109
Remove
Screws D1, D2
WATER TANK 18
SAFETY LIGHT REAR CAP 1
SAFETY LIGHT 29
Remove
Screw A
Remove
Backplate 3, 26
Remove
Screw J
Remove
Safety light 29
Remove
Inlay 7
Remove
Operation knobs 101, 102
Remove
Screws D1, D2
Remove
Handle 13
Remove
Screws E1, E2
Remove
Water tank 18
Remove
Screw F
REPAIR INSTRUCTIONS
- Due to the high voltage of the iron, ONLY the specified cordsets must be used.
- When replacing thermister assembly (Pos 2), ensure torque applied to the screw is
20 kgfcm. Also, handle the thermister assembly with care so as not to damage it.
- No information about the type number and voltage is stamped onto the typeplate.
When replacing the back plate (typeplate is at the bottom), engrave at least the type
number & voltage on the typeplate with a sharp object.
- Parts with numbers from 100 and higher cannot be ordered separately, except 101,
102, 117, 118.
OPTIONAL (accessories)
- No specific issues
GC4250
SOLEPLATE COVER 19
ISOLATION PLUG 20
SOS SEAL 21
DOSING SEAL 22
THERMISTER 2
SOLEPLATE ASSY 23
Remove
Screw A
Remove
Backplate 3, 26
Remove
Inlay 7
Remove
Operation knobs 101, 102
Remove
Screws D1, D2
Remove
Handle 13
Remove
Screws E1, E2
Remove
Water tank 18
Remove
Screw F
Remove
Heat shield
Remove
Screws G1, G2
Remove
Soleplate cover 19
2-4
Advertisement
