Operation - Fantech GDC124CSS Installation, Operation And Maintenance Manual

4

Operation

Built in electrical safety
For your safety and protection this appliance is manufactured with a grounded plug on its power cord. The power cord must be plugged into a properly
grounded receptacle. If a grounded receptacle does not exist, have one installed by a certified electrician. Do not cut or remove the grounding prong on
the power cord plug if equipped. We recommend that this electrical circuit/ receptacle operate under a separate breaker or fuse.
This appliance complies with the suppression requirements of EEC directive 76/889 + 82/499. Recommended limits of use: Temperatures: 0 to 35°C,
Relative humidity: 20 to 80%.
Location of Unit
Minimum 25cm distance from walls. Close all doors and windows. (figure 1)
Initial Star-up
Check the rating plate for the appropriate power supply needed by your unit. Connect the
dehumidifier. Ensure that one of the water collection options is working and active. Depress the ON
switch.
Control Panel Settings
(A) ON/OFF Switch
Depress the switch to start or stop the dehumidifier. "O" for power off, "I" for power on.
(B) Hour Counter
The counter will accumulate and display the total running hours of the unit in 1/100 of an hour. It
can not be reset to zero. No user input is required.
(C) Pump Purge: (Green button - Some models)
Depressing this button activates the condensate pump. This can be used to empty the pump
reservoir. The button must be held depressed until drain line is clear of water, this is when pump
reservoir is empty. The dehumidifier must be switched "ON
Depress the switch long enough to perform the function. Prolonged depression of the
switches could harm the equipment.
(D) Hot Gas On Demand: (Red button - some models)
Depressing this button activates the hot gas defrost system. This can be used to clear the
evaporator coil of frost if required. The button must be held depressed until the evaporator coil is
cleared of frost. The dehumidifier must be switched "ON".
Depress the switch long enough to perform the function. Prolonged depression of the
switches could harm the equipment.
Automatic Defrost Cycle
All units are equipped with an automatically activated (thermostat controlled) Defrost cycle to
automatically defrost the evaporator coils.
fantech
(figure 2)
".
Figure 1
Figure 2
C
D
A
B