Dri-Eaz Sahara ProX3 115V Owner's Manual

READ AND SAVE THESE INSTRUCTIONS
WARNING
ELECTRIC SHOCK HAZARD
This unit must be electrically
grounded
Use only on GFCI protected
receptacles
The power cord is equipped with a 3-
prong grounding plug. Use only with
a matching receptacle.
Do not cut off the grounding prong.
Do not use an adapter.
Do not use with a damaged power
cord.
Do not use an extension cord.
To reduce risk of fire or electric shock,
do not use this airmover with any solid
-state speed control device.
NOTE: Humidity will rise with the use of
TurboDryers because they lift moisture
from wet materials into the air. To learn
about managing humidity during drying,
contact your local distributor or call Dri-
Eaz Education at 800-575-5152.
07-01537D F351-120V 2013-05 Warranty 07-00419
Owner's Manual
Sahara ProX3 (115V Model)
http://www.LBpatents.com
Patents:
P
LACING
When drying the interior of a building, use at least one TurboDryer
per water-damaged room, or one every 200 square feet. Try to get
airflow to all wet surfaces. Open interior doors to improve air circula-
tion, and brace doors to prevent them from blowing shut.
Do not move or carry a TurboDryer while under operation. When the unit
is in motion, the powerful airflow is hard to control, and can produce
rapid and unpredictable movement.
Do not allow children to play with or around TurboDryers. If they lift or
get a unit off balance, the powerful airflow can cause the TurboDryer to
move rapidly, risking injury.
Do not alter or modify your Dri-Eaz product in any way. Use only re-
placement parts authorized by Dri-Eaz Products, Inc. Modifications or
use of unapproved parts could create a hazard and will void your war-
ranty. Contact your authorized Dri-Eaz distributor for assistance.
O
PERATING
1. Locate the electrical cord and plug into a standard 3-prong outlet.
2. Set the switch to the desired speed, based on amp draw as listed
by the switch on the side control panel.
T A
HE UXILIARY
You can "daisy chain" or interconnect up to three Sahara Pro X3 units
to customize your drying needs. The unit can conduct a maximum of
12 amps when it is turned off or 8 amps when it is turned on.
R C
ED IRCUIT
The primary purpose of the circuit breaker is to protect the machine. It
turns the unit off when more than 12 amps are run through the on-unit
circuit.
G
ROUND
The GFCI protects the user. Should it detect a sudden "ground fault,"
the GFCI will interrupt the electric current. The GFCI will also trip
when a short circuit or overload occurs. If the GFCI "trips," unplug the
unit and look for potential hazards (standing water, frayed cord, etc.)
that might cause an electrical surge. Relocate the unit and plug into a
different outlet. Then push the "Reset" button and check to make sure
it is operating. If so, continue use; if not, call a Dri-Eaz tech specialist
at 800-575-5152.
DRI-EAZ PRODUCTS, INC.
15180 Josh Wilson Road, Burlington, WA USA 98233
Fax: (360) 757-7950 Phone US: (360) 757-7776
www.dri-eaz.com
Y T D
OUR URBO RYERS
WARNING
Y T D
OUR URBO RYER
O
UTLET
B S
REAKER WITCH
F C I
AULT IRCUIT NTERRUPTER
1 Dri-Eaz Products, Inc. 1