Recharging The Battery; Troubleshooting Tips - XEPA TECHNOLOGIES PSD3 User Manual

Recharging the Battery:


Plug in the solar panel charger; the battery will charge whether the switch
is set to OFF, AUTO, or TEST positions.

Light will not work once battery is removed from the jacket. Please plug in
the solar panel charger after put battery back to the jacket to reactivate the
light
Warning: Do not mix old and new batteries and Do not mix alkaline, standard
(carbonzinc) or rechargeable (ni-cad, ni-mh, etc) batteries. Only Xepa
Technology rechargeable batteries should be used! It is available on
www.xepatech.com
FCC Part 15 Class B & C
CAUTION: Modifications not approved by the party responsible for compliance
could void user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio or television reception.
The source of the interference can be tested by turning the equipment off and
on. The user is encouraged to try to correct the interference by one or more of
the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and the receiver.

Connect the equipment into an outlet/circuit different from where the
receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

Troubleshooting Tips

Symptom
The light will not
illuminate.
or contact 800-284-8828.

Switch to TEST mode to check that the light can
illuminate even during the daytime.

Make sure battery is not drained and solar panel plug
is fully inserted.
Possible Solution
6