Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for XEPA TECHNOLOGIES PSD3
- Page 1 Solar Powered LED Security Camera Light & Wireless DVR MODEL: PSD3 Please do not return this item to the store. For service or questions about your solar light, call our customer service at 800.284.8828 (8:30am - 5:30pm, Monday to Friday, Pacific Time) or visit www.xepatech.com.
-
Page 2: Important Safety Information
Thank you for purchasing the PSD3 Solar-Powered Security Light with the digital wireless DVR security system—the most cost-effective way to illuminate and protect your home, business, and recreational areas. With its easy setup and lightweight design, this light conforms to most of your lighting needs and is especially useful where an electrical outlet is not accessible. -
Page 3: Product Profile
5. Antenna Installation Recommendations: The PSD3 light fixture should be installed on a flat and stable surface—the higher the light is placed, the larger the area of illumination. Avoid installing the light near an air conditioner, heater, or high-voltage system, since quick changes in temperature may activate the motion- detection system and run down the light’s power. -
Page 4: Installing The Solar Panel
Installing the LED Security Light: Mark holes on the wall through the Installation template. ” Drill holes with a 3/16 drill bit. Gently tap the plastic anchors into the holes until they are flush with the mounting surface. Secure the screws into the plastic anchors—leave approximately 3/16” of each screw exposed for mounting the unit. - Page 5 Find a location for the solar panel that receives direct sunlight for a minimum of 6-8 hours a day; and is within 15’ of where the Security Light will be installed. Mark the holes through the mounting template. Using a 3/16” drill bit, drill holes in the spots you marked. Gently tap the mounting anchors into the holes until they are flush with the mounting surface.
-
Page 6: Recharging The Battery
Recharging the Battery: Plug in the solar panel charger; the battery will charge whether the switch is set to OFF, AUTO, or TEST positions. Light will not work once battery is removed from the jacket. Please plug in the solar panel charger after put battery back to the jacket to reactivate the light Warning: Do not mix old and new batteries and Do not mix alkaline, standard... - Page 7 Make sure the battery plug is connected inside the battery compartment. Set switch to OFF or AUTO mode and allow the solar panel to absorb direct sunlight for two or more days to recharge the battery. Make sure there is no other brighter light source near the unit at night time.
-
Page 8: Specifications
APEX will replace the defective part(s). If any of the product parts are found to be missing, please contact APEX within ten (10) days of purchase. XEPA TECHNOLOGIES by APEX DIGITAL INC. 4401 Eucalyptus Avenue, Suite 100 Chino, California 91710 01.06.2012...